Stihl 090 Vanliga problem och enkla lösningar

De Stihl 090 är en effektiv motorsåg som är enkel att använda och underhålla. i alla fall, there are a few common problems that can occur with this model, and easy solutions can help you overcome them. Till exempel, if your chain has been breaking easily, det kan vara dags att byta ut det. Eller, if you don’t have enough power to chop through stubborn branches, it might be time to buy a stronger chain.

Felsökning

Stihl 090: Inte att börja

  1. Först, make sure that there is fresh, clean fuel in the tank.
  2. Nästa, check the spark plug to see if it is clean and in good condition. If the spark plug looks dirty or damaged, byt ut den mot en ny.
  3. Till sist, check the air filter to see if it is clean and free of debris. Om luftfiltret är smutsigt, byt ut den mot en ny.

Stihl 090: Högt ljud

When your Stihl 090 is making a loud noise, det finns några saker du kan göra för att försöka lösa problemet.

  1. Först, check to see if the chain is tight. If the chain is loose, tighten it according to the manufacturer’s instructions.
  2. If the chain is already tight, then the problem may be with the guide bar. Inspect the guide bar to see if it is bent or damaged in any way. If the guide bar is bent or damaged, det kommer att behöva bytas ut.
  3. Till sist, om problemet kvarstår, you may need to take your saw to a qualified technician for further diagnosis and repair.

Stihl 090: Långsamma hjul

When your Stihl 090 har långsamma hjul, there are a few things you can do to fix the problem.

  1. Först, check the air pressure in the tires. If the pressure is low, inflate the tires to the recommended pressure.
  2. Nästa, kontrollera kedjespänningen. Om kedjan är för lös, it can cause the wheels to spin slowly. Adjust the chain tension so that it is tight, but not too tight.
  3. Till sist, make sure that the brakes are not dragging. If the brakes are dragging, they can cause the wheels to spin slowly. Adjust the brakes so that they are not dragging.

Stihl 090: Dör plötsligt när man skär

For your Stihl 090 dör plötsligt när man skär, det finns några saker du kan göra för att felsöka problemet.

Först, check the fuel tank to make sure there is enough fuel. If the tank is empty, fyll på och försök igen. If the tank is full, check the spark plug to see if it is dirty or damaged. Om tändstiftet ser bra ut, check the air filter to see if it is clean. Om luftfiltret är smutsigt, replace it. If the air filter is clean, check the carburetor to see if it is dirty or damaged. Om förgasaren är smutsig, clean it or replace it.

Stihl 090: Motorn tappar kraften gradvis

For your Stihl 090 is losing power gradually, there are a few things that could be causing the problem.

Först, check the air filter to see if it is clean. If it is dirty, rengör den eller byt ut den mot en ny. Nästa, kontrollera tändstiftet för att se om det är smutsigt. Om det är, clean it or replace it. Till sist, check the fuel mixture to see if it is too rich. Om det är, adjust the mixture or replace the fuel.

Stihl 090: Kedjan tenderar att vara lös

When you’re having trouble with your Stihl 090 chain coming loose, what to do?

Först, kontrollera kedjespänningen. Om kedjan är för lös, it will come off easily. Andra, check the bar clamping screws. These screws hold the bar to the saw and need to be tight in order to keep the chain from coming off. Till sist, check the guide bar itself. If it’s damaged or bent, it could be causing the chain to come off.

Stihl 090: Olja på motorsågen fungerar inte

If the oiler on your chainsaw isn’t working, it might be because the carburetor isn’t getting enough air.

Here’s how to fix that: Disconnect the power cord from the chainsaw. This will stop it from being run and make it easier to fix the issue. Open up the carburetor by pulling out thebaseplate and unscrewing the four screws at the top of it. You should now see a black liquid coming out of it. Om inte, replace or rebuild the carburetor as needed based on your chainsaw model and availability.

Stihl 090

Instruktioner

Hur man återställer Stihl 090 motorsåg?

There are a few ways to reset the Stihl 090 saw blade, but the most common is by using a phillips screwdriver to unscrew the blade cover and remove the blade. Another way is to use a plunger to suction onto the top of the blade and then push and pull until the blade pops out.

Hur man kalibrerar en Stihl 090 motorsåg?

  1. Before you start calibrating your Stihl 090, make sure that it is properly cleaned and lubricated.
  2. To calibrate your Stihl 090, you will need a few tools, including a screwdriver, a wrench, and a feeler gauge.
  3. The first step is to adjust the idle speed. Att göra detta, use the screwdriver to turn the idle speed screw until the saw is running at the desired speed.
  4. Nästa, you will need to adjust the carburetor. Att göra detta, use the wrench to turn the carburetor adjustment screws until the engine is running at the desired speed.
  5. Till sist, you will need to adjust the fuel mixture. Att göra detta, use the feeler gauge to measure the gap between the piston and the cylinder. Sedan, use the screwdriver to turn the fuel mixture screw until the desired gap is achieved.

Hur man justerar förgasaren på en Stihl 090 motorsåg?

Here’s how:

  1. Open the throttle body cover. This will expose the carburetor and its screws.
  2. Remove the carburetor from the engine by gently pushing it out from under the throttle body with a screwdriver or your hands.
  3. On older Stihl engines, there is a small Allen key hidden behind one of the screws on top of the carburetor. To remove it, turn it until it becomes loose and then pull it out with a hex wrench or your fingers.

Hur man byter baroljepump för Stihl 090 motorsåg?

Here is a step-by-step guide on how to do this:

  1. Remove the bar from the chainsaw.
  2. Unscrew the bar oil pump from the housing.
  3. Take out the old pump and clean the housing.
  4. Install the new pump and screw it into the housing.
  5. Replace the bar and tighten the bolts.
  6. Test the chainsaw to make sure the new pump is working properly.

Hur man justerar kedjespännaren på Stihl 090 motorsåg?

Here are some tips to adjust the chain tensioner on Stihl 090:

  1. Make sure the chain tensioner is in the correct position before starting to adjust it.
  2. Adjust the tensioner according to the size of the chainsaw chain.
  3. Use a wrench or another tool to tighten or loosen the screws on the tensioner so that it’s properly adjusted.

Stihl 090

Vanliga frågor

När gjorde Stihl 090 komma ut?

Den Stihl 090 chainsaw was made in Germany and produced between 1968 – 1977 – the Stihl 090G between 1969 – 1985. De 090 is the largest chainsaw ever produced, with more power than the likes of the Stihl 880 and 500i, though without all of the modern improvements such as anti-vibration systems.

Vilken CC är en Stihl 090?

Den Stihl 090 is a 137cc chainsaw. It is a great choice for cutting firewood or felling trees. It is a powerful saw that will get the job done quickly and efficiently.

Vad är Stihl 090 Specifikation?

  • Förflyttning: 137cc motor
  • Kraft: 8.5 hästkraft (though another source states 11.5)
  • Vikt: 25+ lbs
  • Type: Manual and automatic oiler
  • Special feature: Has a throttle lock (making it good for milling)
  • Tensioner: Front placed chain tensioner

Hur många hästkrafter gör en Stihl 090 ha?

Den Stihl 090 har 8.5 hästkraft. This is plenty of power for most cutting jobs. The saw can easily handle big chunks of wood and can even cut through metal if necessary. Med så mycket kraft, den Stihl 090 can handle just about anything you need it to.

Stihl 090

Hur mycket kostar en Stihl 090 vikt?

Den Stihl 090 väger in på runt 25 pund. It is lightweight and easy to use, making it perfect for any project. Because it is so small, it can be difficult to find a weight that will fit your needs. i alla fall, den Stihl 090 weight can be replaced by an optional attachment, such as the 090-A or the 090-C. If you do not have a weight available, you can still use the Stihl 090 with an optional blade system.

Vilken kedja gör Stihl 090 har från fabriken?

Den Stihl 090 levereras med en standard 3/8″ Picco Micro 3 (PM3) saw chain from the factory. This chain is designed for use with the Stihl 090, and is a good all-around saw chain for general cutting and pruning tasks.

Vad är Stihl 090 max stånglängd?

Den Stihl 090 har en maximal stånglängd på 36 tum. This saw is designed for heavy-duty use and can handle cutting jobs that require a lot of power. It is a powerful saw that can cut through thick wood quickly and easily.

Hur mycket kostar en Stihl 090?

Den Stihl 090 typically retails for around $1000, although the exact price will vary depending on the retailer and the specific model.

Var hittar man Stihl 090 till salu?

  • One option is to go directly to the Stihl website and see if they have any listings for authorized dealers in your area.
  • Another option is to check out online retailers such as Amazon or eBay.
  • Till sist, you could also check with your local hardware store or home improvement center to see if they have any Stihl 090s for sale.

Gör Stihl 090 kom med ett fodral?

Den Stihl 090 kommer med ett fodral, but it is an optional extra. If you choose to purchase the optional case, it will be an additional cost.

Slutet

Sammanfattningsvis, there are many Stihl 090 issues that one can face and solutions that are easy to find. If you are having trouble with your Stihl 090 motorsåg, be sure to read our reviews and take the advice of our experts to solve your problems.