Stihl 090 Vanlige problemer og enkle løsninger

De Stihl 090 er en effektiv motorsag som er enkel å bruke og vedlikeholde. men, there are a few common problems that can occur with this model, and easy solutions can help you overcome them. For eksempel, if your chain has been breaking easily, det kan være på tide å erstatte det. Eller, if you don’t have enough power to chop through stubborn branches, it might be time to buy a stronger chain.

Feilsøking

Stihl 090: Ikke for å starte

  1. Først, make sure that there is fresh, clean fuel in the tank.
  2. Neste, check the spark plug to see if it is clean and in good condition. If the spark plug looks dirty or damaged, erstatte den med en ny.
  3. Til slutt, check the air filter to see if it is clean and free of debris. Hvis luftfilteret er skittent, erstatte den med en ny.

Stihl 090: Høy lyd

When your Stihl 090 lager en høy lyd, det er et par ting du kan gjøre for å prøve å fikse problemet.

  1. Først, check to see if the chain is tight. If the chain is loose, tighten it according to the manufacturer’s instructions.
  2. If the chain is already tight, then the problem may be with the guide bar. Inspiser sverdet for å se om det er bøyd eller skadet på noen måte. If the guide bar is bent or damaged, den må skiftes ut.
  3. Til slutt, hvis problemet vedvarer, you may need to take your saw to a qualified technician for further diagnosis and repair.

Stihl 090: Langsomme hjul

When your Stihl 090 har trege hjul, det er et par ting du kan gjøre for å fikse problemet.

  1. Først, check the air pressure in the tires. If the pressure is low, inflate the tires to the recommended pressure.
  2. Neste, sjekk kjedespenningen. Hvis kjedet er for løst, it can cause the wheels to spin slowly. Adjust the chain tension so that it is tight, men ikke for stramt.
  3. Til slutt, make sure that the brakes are not dragging. If the brakes are dragging, they can cause the wheels to spin slowly. Adjust the brakes so that they are not dragging.

Stihl 090: Plutselig dør mens du skjærer

For your Stihl 090 dør plutselig mens du skjærer, det er noen ting du kan gjøre for å feilsøke problemet.

Først, check the fuel tank to make sure there is enough fuel. Hvis tanken er tom, fyll den på nytt og prøv igjen. If the tank is full, check the spark plug to see if it is dirty or damaged. Hvis tennpluggen ser bra ut, sjekk luftfilteret for å se om det er rent. Hvis luftfilteret er skittent, Erstatt det. Hvis luftfilteret er rent, check the carburetor to see if it is dirty or damaged. Hvis forgasseren er skitten, rengjør den eller bytt den ut.

Stihl 090: Motoren mister kraften gradvis

For your Stihl 090 is losing power gradually, there are a few things that could be causing the problem.

Først, sjekk luftfilteret for å se om det er rent. Hvis det er skittent, rengjør den eller bytt den ut med en ny. Neste, sjekk tennpluggen for å se om den er tilsmusset. Hvis det er, rengjør den eller bytt den ut. Til slutt, check the fuel mixture to see if it is too rich. Hvis det er, adjust the mixture or replace the fuel.

Stihl 090: Kjedet har en tendens til å være løst

When you’re having trouble with your Stihl 090 chain coming loose, what to do?

Først, sjekk kjedespenningen. Hvis kjedet er for løst, it will come off easily. Sekund, check the bar clamping screws. These screws hold the bar to the saw and need to be tight in order to keep the chain from coming off. Til slutt, check the guide bar itself. If it’s damaged or bent, it could be causing the chain to come off.

Stihl 090: Olje på motorsag fungerer ikke

If the oiler on your chainsaw isn’t working, it might be because the carburetor isn’t getting enough air.

Here’s how to fix that: Disconnect the power cord from the chainsaw. This will stop it from being run and make it easier to fix the issue. Open up the carburetor by pulling out thebaseplate and unscrewing the four screws at the top of it. You should now see a black liquid coming out of it. Hvis ikke, replace or rebuild the carburetor as needed based on your chainsaw model and availability.

Stihl 090

Bruksanvisning

Slik tilbakestiller du Stihl 090 motorsag?

There are a few ways to reset the Stihl 090 saw blade, but the most common is by using a phillips screwdriver to unscrew the blade cover and remove the blade. Another way is to use a plunger to suction onto the top of the blade and then push and pull until the blade pops out.

Hvordan kalibrere en Stihl 090 motorsag?

  1. Before you start calibrating your Stihl 090, make sure that it is properly cleaned and lubricated.
  2. To calibrate your Stihl 090, you will need a few tools, including a screwdriver, a wrench, and a feeler gauge.
  3. The first step is to adjust the idle speed. Å gjøre dette, use the screwdriver to turn the idle speed screw until the saw is running at the desired speed.
  4. Neste, you will need to adjust the carburetor. Å gjøre dette, use the wrench to turn the carburetor adjustment screws until the engine is running at the desired speed.
  5. Til slutt, you will need to adjust the fuel mixture. Å gjøre dette, use the feeler gauge to measure the gap between the piston and the cylinder. Deretter, use the screwdriver to turn the fuel mixture screw until the desired gap is achieved.

Hvordan justere forgasseren på en Stihl 090 motorsag?

Here’s how:

  1. Open the throttle body cover. This will expose the carburetor and its screws.
  2. Remove the carburetor from the engine by gently pushing it out from under the throttle body with a screwdriver or your hands.
  3. On older Stihl engines, there is a small Allen key hidden behind one of the screws on top of the carburetor. To remove it, turn it until it becomes loose and then pull it out with a hex wrench or your fingers.

Hvordan bytte baroljepumpe for Stihl 090 motorsag?

Here is a step-by-step guide on how to do this:

  1. Remove the bar from the chainsaw.
  2. Unscrew the bar oil pump from the housing.
  3. Take out the old pump and clean the housing.
  4. Install the new pump and screw it into the housing.
  5. Replace the bar and tighten the bolts.
  6. Test the chainsaw to make sure the new pump is working properly.

Slik justerer du kjedestrammeren på Stihl 090 motorsag?

Here are some tips to adjust the chain tensioner on Stihl 090:

  1. Make sure the chain tensioner is in the correct position before starting to adjust it.
  2. Adjust the tensioner according to the size of the chainsaw chain.
  3. Use a wrench or another tool to tighten or loosen the screws on the tensioner so that it’s properly adjusted.

Stihl 090

Vanlige spørsmål

Når gjorde Stihl 090 kom ut?

Stihl 090 chainsaw was made in Germany and produced between 1968 – 1977 – the Stihl 090G between 1969 – 1985. De 090 is the largest chainsaw ever produced, with more power than the likes of the Stihl 880 and 500i, though without all of the modern improvements such as anti-vibration systems.

Hvilken CC er en Stihl 090?

Stihl 090 is a 137cc chainsaw. It is a great choice for cutting firewood or felling trees. It is a powerful saw that will get the job done quickly and efficiently.

Hva er Stihl 090 spesifikasjon?

  • Forskyvning: 137cc motor
  • Makt: 8.5 hestekrefter (though another source states 11.5)
  • Vekt: 25+ lbs
  • Type: Manual and automatic oiler
  • Special feature: Has a throttle lock (making it good for milling)
  • Tensioner: Front placed chain tensioner

Hvor mange hestekrefter har en Stihl 090 ha?

Stihl 090 har 8.5 hestekrefter. This is plenty of power for most cutting jobs. The saw can easily handle big chunks of wood and can even cut through metal if necessary. With this much power, den Stihl 090 can handle just about anything you need it to.

Stihl 090

Hvor mye koster en Stihl 090 vekt?

Stihl 090 weighs in at around 25 pounds. It is lightweight and easy to use, making it perfect for any project. Because it is so small, it can be difficult to find a weight that will fit your needs. men, den Stihl 090 weight can be replaced by an optional attachment, such as the 090-A or the 090-C. If you do not have a weight available, you can still use the Stihl 090 with an optional blade system.

Hvilken kjede gjør Stihl 090 har fra fabrikken?

Stihl 090 leveres med en standard 3/8" Picco Micro 3 (PM3) saw chain from the factory. This chain is designed for use with the Stihl 090, and is a good all-around saw chain for general cutting and pruning tasks.

Hva er Stihl 090 maks stanglengde?

Stihl 090 har en maksimal stanglengde på 36 tommer. This saw is designed for heavy-duty use and can handle cutting jobs that require a lot of power. It is a powerful saw that can cut through thick wood quickly and easily.

Hvor mye koster en Stihl 090?

Stihl 090 typically retails for around $1000, although the exact price will vary depending on the retailer and the specific model.

Hvor finner du Stihl 090 til salgs?

  • One option is to go directly to the Stihl website and see if they have any listings for authorized dealers in your area.
  • Another option is to check out online retailers such as Amazon or eBay.
  • Til slutt, you could also check with your local hardware store or home improvement center to see if they have any Stihl 090s for sale.

Gjør Stihl 090 kom med sak?

Stihl 090 kommer med etui, but it is an optional extra. If you choose to purchase the optional case, it will be an additional cost.

Slutten

For å konkludere, there are many Stihl 090 issues that one can face and solutions that are easy to find. If you are having trouble with your Stihl 090 motorsag, be sure to read our reviews and take the advice of our experts to solve your problems.