Det Stihl 090 er en effektiv motorsav, der er nem at bruge og vedligeholde. Imidlertid, der er et par almindelige problemer, der kan opstå med denne model, og nemme løsninger kan hjælpe dig med at overvinde dem. For eksempel, hvis din kæde er gået i stykker let, det kan være på tide at udskifte det. Eller, if you don’t have enough power to chop through stubborn branches, it might be time to buy a stronger chain.

Fejlfinding

Stihl 090: Not to start

1. Først, make sure that there is fresh, clean fuel in the tank.
2. Næste, check the spark plug to see if it is clean and in good condition. If the spark plug looks dirty or damaged, erstatte den med en ny.
3. Langt om længe, check the air filter to see if it is clean and free of debris. Hvis luftfilteret er snavset, erstatte den med en ny.

Stihl 090: Loud noise

When your Stihl 090 is making a loud noise, der er et par ting, du kan gøre for at prøve at løse problemet.

1. Først, check to see if the chain is tight. If the chain is loose, tighten it according to the manufacturer’s instructions.
2. If the chain is already tight, then the problem may be with the guide bar. Inspect the guide bar to see if it is bent or damaged in any way. If the guide bar is bent or damaged, det skal udskiftes.
3. Langt om længe, hvis problemet fortsætter, you may need to take your saw to a qualified technician for further diagnosis and repair.

Stihl 090: Slow wheels

When your Stihl 090 har langsomme hjul, there are a few things you can do to fix the problem.

1. Først, check the air pressure in the tires. If the pressure is low, inflate the tires to the recommended pressure.
2. Næste, kontrollere kædespændingen. Hvis kæden er for løs, it can cause the wheels to spin slowly. Adjust the chain tension so that it is tight, but not too tight.
3. Langt om længe, make sure that the brakes are not dragging. If the brakes are dragging, they can cause the wheels to spin slowly. Adjust the brakes so that they are not dragging.

Stihl 090: Suddenly dies while cutting

For your Stihl 090 dør pludselig under skæring, there are a few things you can do to troubleshoot the problem.

Først, check the fuel tank to make sure there is enough fuel. If the tank is empty, fyld den op igen og prøv igen. If the tank is full, check the spark plug to see if it is dirty or damaged. Hvis tændrøret ser godt ud, tjek luftfilteret for at se, om det er rent. Hvis luftfilteret er snavset, Erstat det. Hvis luftfilteret er rent, check the carburetor to see if it is dirty or damaged. Hvis karburatoren er snavset, clean it or replace it.

Stihl 090: Engine loses power gradually

For your Stihl 090 is losing power gradually, there are a few things that could be causing the problem.

Først, tjek luftfilteret for at se, om det er rent. Hvis det er snavset, rengør den eller udskift den med en ny. Næste, tjek tændrøret for at se, om det er snavset. Hvis det er, clean it or replace it. Langt om længe, check the fuel mixture to see if it is too rich. Hvis det er, adjust the mixture or replace the fuel.

Stihl 090: The chain tends to be loose

When you’re having trouble with your Stihl 090 chain coming loose, what to do?

Først, kontrollere kædespændingen. Hvis kæden er for løs, it will come off easily. Sekund, check the bar clamping screws. These screws hold the bar to the saw and need to be tight in order to keep the chain from coming off. Langt om længe, check the guide bar itself. If it’s damaged or bent, it could be causing the chain to come off.

Stihl 090: Oiler on chainsaw is not working

If the oiler on your chainsaw isn’t working, it might be because the carburetor isn’t getting enough air.

Here’s how to fix that: Disconnect the power cord from the chainsaw. This will stop it from being run and make it easier to fix the issue. Open up the carburetor by pulling out thebaseplate and unscrewing the four screws at the top of it. You should now see a black liquid coming out of it. Hvis ikke, replace or rebuild the carburetor as needed based on your chainsaw model and availability.

Instruktioner

Sådan nulstiller du Stihl 090 kædesav?

There are a few ways to reset the Stihl 090 saw blade, but the most common is by using a phillips screwdriver to unscrew the blade cover and remove the blade. Another way is to use a plunger to suction onto the top of the blade and then push and pull until the blade pops out.

Sådan kalibreres en Stihl 090 kædesav?

1. Before you start calibrating your Stihl 090, make sure that it is properly cleaned and lubricated.
2. To calibrate your Stihl 090, you will need a few tools, including a screwdriver, a wrench, and a feeler gauge.
3. The first step is to adjust the idle speed. At gøre dette, use the screwdriver to turn the idle speed screw until the saw is running at the desired speed.
4. Næste, you will need to adjust the carburetor. At gøre dette, use the wrench to turn the carburetor adjustment screws until the engine is running at the desired speed.
5. Langt om længe, you will need to adjust the fuel mixture. At gøre dette, use the feeler gauge to measure the gap between the piston and the cylinder. Derefter, use the screwdriver to turn the fuel mixture screw until the desired gap is achieved.

Sådan justeres karburatoren på en Stihl 090 kædesav?

Here’s how:

1. Open the throttle body cover. This will expose the carburetor and its screws.
2. Remove the carburetor from the engine by gently pushing it out from under the throttle body with a screwdriver or your hands.
3. On older Stihl engines, there is a small Allen key hidden behind one of the screws on top of the carburetor. To remove it, turn it until it becomes loose and then pull it out with a hex wrench or your fingers.

Sådan udskiftes stangoliepumpe til Stihl 090 kædesav?

Here is a step-by-step guide on how to do this:

1. Remove the bar from the chainsaw.
2. Unscrew the bar oil pump from the housing.
3. Take out the old pump and clean the housing.
4. Install the new pump and screw it into the housing.
5. Replace the bar and tighten the bolts.
6. Test the chainsaw to make sure the new pump is working properly.

Sådan justeres kædestrammeren på Stihl 090 kædesav?

Here are some tips to adjust the chain tensioner on Stihl 090:

1. Make sure the chain tensioner is in the correct position before starting to adjust it.
2. Adjust the tensioner according to the size of the chainsaw chain.
3. Use a wrench or another tool to tighten or loosen the screws on the tensioner so that it’s properly adjusted.

Ofte stillede spørgsmål

Hvornår gjorde Stihl 090 kom ud?

Den Stihl 090 chainsaw was made in Germany and produced between 1968 – 1977 – the Stihl 090G between 1969 – 1985. Det 090 is the largest chainsaw ever produced, with more power than the likes of the Stihl 880 and 500i, though without all of the modern improvements such as anti-vibration systems.

Hvilken CC er en Stihl 090?

Den Stihl 090 is a 137cc chainsaw. It is a great choice for cutting firewood or felling trees. It is a powerful saw that will get the job done quickly and efficiently.

Hvad er Stihl 090 specifikation?

• Forskydning: 137cc motor
• Strøm: 8.5 hestekræfter (selvom en anden kilde siger 11.5)
• Vægt: 25+ lbs
• Type: Manuel og automatisk smører
• Special feature: Har gasspjæld (gør den god til fræsning)
• Spænder: Forreste placeret kædestrammer

Hvor mange hestekræfter har en Stihl 090 har?

Den Stihl 090 har 8.5 hestekræfter. This is plenty of power for most cutting jobs. The saw can easily handle big chunks of wood and can even cut through metal if necessary. Med så meget kraft, den Stihl 090 can handle just about anything you need it to.

Hvor meget koster en Stihl 090 vægt?

Den Stihl 090 weighs in at around 25 pund. It is lightweight and easy to use, making it perfect for any project. Because it is so small, it can be difficult to find a weight that will fit your needs. Imidlertid, den Stihl 090 weight can be replaced by an optional attachment, such as the 090-A or the 090-C. If you do not have a weight available, you can still use the Stihl 090 with an optional blade system.

Hvilken kæde gør Stihl 090 har fra fabrikken?

Den Stihl 090 leveres med en standard 3/8" Picco Micro 3 (PM3) saw chain from the factory. This chain is designed for use with the Stihl 090, and is a good all-around saw chain for general cutting and pruning tasks.

Hvad er Stihl 090 max stanglængde?

Den Stihl 090 has a maximum bar length of 36 tommer. This saw is designed for heavy-duty use and can handle cutting jobs that require a lot of power. It is a powerful saw that can cut through thick wood quickly and easily.

Hvor meget koster en Stihl 090?

Den Stihl 090 typically retails for around $1000, although the exact price will vary depending on the retailer and the specific model.

Hvor finder man Stihl 090 til salg?

• One option is to go directly to the Stihl website and see if they have any listings for authorized dealers in your area.
• Another option is to check out online retailers such as Amazon or eBay.
• Langt om længe, you could also check with your local hardware store or home improvement center to see if they have any Stihl 090s for sale.

Gør Stihl 090 kom med en sag?

Den Stihl 090 kommer med etui, but it is an optional extra. If you choose to purchase the optional case, it will be an additional cost.

Slutningen

Afslutningsvis, there are many Stihl 090 issues that one can face and solutions that are easy to find. If you are having trouble with your Stihl 090 kædesav, be sure to read our reviews and take the advice of our experts to solve your problems.